Shot Blasting Process Schematization for Rollers Using Slip-Line Method

Abstract

The considered theoretical analysis of the roughness parameters formation of the rolling face of the pinch pass mills, when they are indented with shot, allows to obtain more adequate and convenient theoretical results for use in practice. The formation of a rough layer on the rolling working surface of the pinch pass mill is determined by the impact and penetration of the shots into its surface. When this occurs, the elastic and plastic deformation of the roll materials and shot with the dimple formation and the displacement of a portion of the deformed roll material on the edges of this dimple takes place. The obtained results allow using the mathematical dependencies to control purposefully the process of shot blasting and correct it when texturing the working rolling faces of the pinch pass mills.