Shortening replacement by emulsion and foam template hydroxypropyl methylcellulose (HPMC)-based oleogels in puff pastry dough. Rheological and texture properties

Abstract

Listen

Translate article

Shortening plays an essential function in the formulation of sweet laminated bakery products, but has a potential health risk due to their high percentage of saturated fatty acids. In this paper, the feasibility of hydroxypropyl methylcellulose (HPMC) oleogels prepared with emulsion template (ET) and foam template (FT) approaches as fat sources in a puff pastry dough was investigated. Spreadability and thermal properties of control shortening, 100% ET and FT oleogels and shortening/oleogel (50/50) blends were measured. The different systems were applied as the fat source in a puff pastry dough, and their effect on rheological and texture properties was investigated. Results showed that partial replacement of shortening with oleogels could significantly decrease the firmness values (from 115 to 26 N) (P < 0.05) and increased the spreadability of shortening. The methodology to prepare the oleogel (FT or ET) also significantly affected the texture parameters. FT blends had the highest spreadability with significantly lower firmness values and area under the curve. Thermal values showed that both oleogels could slightly increase the melting point of shortening from 47 to 50 °C. The replacement of shortening with oleogel decreases the viscoelasticity of puff pastry dough and increases its thermal stability but does not significantly change dough viscoelasticity in the shortening/oleogel mixture. These results indicated that both oleogels have promising potential to replace shortening in puff pastry dough formulations, but the ET oleogel showed a more similar behavior to the control shortening than the FT oleogel.