Abstract
Understanding and control of short term precipitation of delta phase in Inconel 718 alloy is of importance as it is used to control grain growth during forging. This precipitation has been studied on both as received and solution treated 718 alloy, in the temperature range 650 to 1020°C and for times up to 10 h. The outer envelope of the transformation – time – temperature (TTT) diagram, which indicates the time at which the delta phase first precipitates during isothermal holding at a given temperature, has been drawn and compared to a critical review of previous information. Precipitation kinetics are also reported for both materials and discussed in the light of the very scarce data available in the open literature. According to these results, the so called 'nose' of the TTT diagram is located at a higher temperature and lower time than predicted from previously published diagrams.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.