Abstract
ABSTRACTThe high cycle fatigue (HCF) behaviors of an additively manufactured (AM) Ti–6Al–4V alloy with fully lamellar microstructures processed electron beam powder bed fusion (EB‐PBF) and wire‐fed electron beam directed energy deposition (Sciaky) routes were compared. Ultrasonic fatigue (USF) testing at the stress ratio of R = −1 was applied to monitor the growth of small cracks initiated at surface micronotches. Crack growth rates lower than 10−8 (m/cycle) at ΔK = 6 MPa·m1/2 were measured in samples processed by both methods. The finer α lath thickness (~1 μm) of the Sciaky samples resulted in a slower fatigue crack growth rate than the EB‐PBF samples with coarser laths. The interaction of cracks with the lamellar microstructures was characterized by electron backscatter diffraction. Crack propagation largely followed the lath interfaces in the Sciaky samples, whereas cracks cut across colonies in the EB‐PBF samples. Different fatigue fracture surface characteristics were observed for the EB‐PBF and Sciaky samples.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Fatigue & Fracture of Engineering Materials & Structures
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
