Shear wave velocity structure of the crust and upper mantle in Southeastern Tibet and its geodynamic implications

Abstract

Southeastern Tibet, which has complex topography and strong tectonic activity, is an important area for studying the subsurface deformation of the Tibetan Plateau. Through the two-station method on 10-year teleseismic Rayleigh wave data from 132 permanent stations in the southeastern Tibetan Plateau, which incorporates ambient noise data, we obtain the interstation phase velocity dispersion data in the period range of 5–150 s. Then, we invert for the shear wave velocity of the crust and upper mantle through the direct 3-D inversion method. We find two low-velocity belts in the mid-lower crust. One belt is mainly in the SongPan-GangZi block and northwestern part of the Chuan-Dian diamond block, whereas the other belt is mainly in the Xiaojiang fault zone and its eastern part, the Yunnan-Guizhou Plateau. The low-velocity belt in the Xiaojiang fault zone is likely caused by plastic deformation or partial melting of felsic rocks due to crustal thickening. Moreover, the significant positive radial anisotropy (VSH>VSV) around the Xiaojiang fault zone further enhances the amplitude of low velocity anomaly in our VSV model. This crustal low-velocity zone also extends southward across the Red River fault and farther to northern Vietnam, which may be closely related to heat sources in the upper mantle. The two low-velocity belts are separated by a high-velocity zone near the Anninghe-Zemuhe fault system, which is exactly in the inner and intermediate zones of the Emeishan large igneous province (ELIP). We find an obvious high-velocity body situated in the crust of the inner zone of the ELIP, which may represent maficultramafic material that remained in the crust when the ELIP formed. In the upper mantle, there is a large-scale low-velocity anomaly in the Indochina and South China blocks south of the Red River fault. The low-velocity anomaly gradually extends northward along the Xiaojiang fault zone into the Yangtze Craton as depth increases. Through our velocity model, we think that southeastern Tibet is undergoing three different tectonic modes at the same time: (1) the upper crust is rigid, and as a result, the tectonic mode is mainly rigid block extrusion controlled by large strike-slip faults; (2) the viscoplastic materials in the middle-lower crust, separated by rigid materials related to the ELIP, migrate plastically southward under the control of the regional stress field and fault systems; and (3) the upper mantle south of the Red River fault is mainly controlled by large-scale asthenospheric upwelling and may be closely related to lithospheric delamination and the eastward subduction and retreat of the Indian plate beneath Burma.