Shear wave velocity measurement during a standard penetration test

Abstract

AbstractAn experiment was carried out to develop a technique to measure shear wave velocity simultaneously with the standard penetration test popular in soil engineering. In the standard penetration test an impact at the bottom of a borehole is produced by weight dropping and may be expected to generate seismic waves. A three‐component geophone was set on the ground surface near the borehole and the waves generated were recorded with a magnetic recorder at successive depths of the penetration test. The predominance of the SV wave obtained with this simple method was assured by measurement of the particle orbit. Signal amplitudes decrease with depth and become less than the noise level at a certain depth. Therefore records from deeper sources must be processed to disclose the shear waves. Since waveforms of SV events generated by blows of the penetration test at a given depth are very similar, the signal to noise ratio would be expected to be improved by a stack of wave trains. A paste‐up of the radial component after stacking was compared with that before stacking and a refinement was clearly recognized.A vertical distribution of shear wave velocity was obtained by reading the onset time at each depth. Shear wave velocities thus obtained were compared with N values from the standard penetration test and specific resistivities from electrical logging in the same borehole. The data were mutually consistent.This experiment showed that a convenient, precise shear wave velocity measurement can be conducted during the routine work of a standard penetration test.