Shear bond strength of a composite resin restoration in primary teeth following cavity preparation using laser- an in-vitro study.

Abstract

To evaluate and compare the shear bond strength of composite resin restorations in primary teeth, following cavity preparation with both traditional dental burs and laser irradiation. One hundred primary molars extracted from the children visiting our department were collected and randomly divided into five groups (A-E) with 20 teeth in each group. In groups A, B, C, D, and E the teeth samples were etched with phosphoric acid, Er; YAG laser followed by acid etching, Er, Cr: YSGG laser followed by acid etching, Er; YAG laser etching only and Er, Cr: YSGG laser etching only, respectively. Following, all the samples were restored with composite resin and subjected to 500 cycles of thermocycling. The shear bond strength of the resin composite was analyzed. The type of fractures was also noted. Data obtained were subjected to statistical analysis. The mean value of shear bond strength of Group A, B, C, D, and E was 17.562 ± 0.810, 15.928 ± 0.415, 14.964 ± 0.566, 11.833 ± 0.533 and 11.187 ± 0.517, respectively. Adhesive failure was most commonly seen in all the groups. The phosphoric acid etching remains a highly effective technique for pre-treating dentin in composite resin restorations. The shear strength of composite resin to the dentin of laser-prepared cavity in primary teeth can be improved by the addition of acid etching.