Shear Bond Strength Between Zirconia and Veneer Ceramic: Effect of Thermocycling and Laser Treatment.

Abstract

Objective: The purpose of this study is to investigate the effect of various presintering and sintered surface treatments and thermocycling on the bond strength between zirconia and veneer ceramics. Background data: Bond stability between zirconia and veneer ceramic is a major concern, and only limited evidence about its longevity is currently available. Moreover, no study has yet evaluated the influence of thermocycling on the bond strength of veneer ceramic to zirconia after Er,Cr:YSGG laser irradiation at different pulse durations and sandblasting. Materials and methods: In this study, 220 nonsintered zirconia specimens were prepared with CAD/CAM and randomly divided into 2 groups; half of the specimens in each group were stored in water for 1 week, and the other half were thermocycled (5000 cycles) between baths of 5°C and 55°C. Specimens were then divided into five subgroups based on the following surface treatments: control (untreated surface), sandblasting (120 μm Al2O3), and Er,Cr: YSGG laser irradiations (3 W-8 Hz, 3 W-15 Hz, and 3 W-20 Hz, MGG 6 laser tip, for 20 sec, distance of 10 mm, water/airflow of 55% and 65%). Morphological assessment was done using atomic force microscopy and scanning electron microscopy, and phase transformation was assessed by X-ray diffractometry. All specimens were then veneered with veneering ceramic, and bond strength test using a universal testing device at a 1 mm/min crosshead speed. Data were evaluated by Kruskal-Wallis variance analysis and the Mann-Whitney U test. Results: There was no significant difference in the bonding strength values among the (p > 0.05). Thermocycling reduced the bond strength, but it was not significant (p > 0.05), except for the presintering 20 Hz group (p < 0.02). Conclusions: Application of thermocycling to sintered zirconia specimens may be detrimental to the shear bond strength of zirconia ceramics. Treating the zirconia surface after sintering is not recommended, due to the decrease in bond strength.