Abstract

ABSTRACT Atmospheric turbulence profile plays an important role in designing and operating adaptive optics (AO) systems with multiple laser guide stars. To obtain representative free atmospheric profiles and resolved ground layer profiles for future AO systems at the Subaru telescope, we are conducting the Shack–Hartmann Atmospheric tuRbulence Profiling Experiment at the Subaru Telescope project. In this project, we develop a turbulence profiler comprising two Shack–Hartmann (SH) sensors to observe a pair of bright stars through the Subaru telescope with high spatial sampling by 2 cm subapertures. We perform two analyses on the SH spot data: variance analysis on the spot scintillation for free atmospheric profiles, and on the spot slope for ground layer profiles. This paper introduces the initial results of free atmospheric profiles as well as total seeing values and wind profiles obtained by the first two engineering runs. The free atmospheric profiles reconstructed by the two independent SH sensors show good agreement. The results are also consistent with simultaneous measurements by another profiler except for turbulence strength at ∼1 km, which is explained by an overestimation problem of scintillation-based profilers. Measured total seeing values are also smaller than the simultaneous measurements, possibly due to the difference in ground layer turbulence between the two sites. The wind profiles show good consistency with the direct measurements by a rawinsonde. Through this study, we establish a method to constrain the free atmospheric profile, the total seeing, and the wind profile by analysing data from a single SH sensor with fine subapertures.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call