Sharkskin and oscillating melt fracture: Why in slit and capillary dies and not in annular dies?

Abstract

AbstractThe sharkskin and stick‐slip polymer extrusion instabilities are studied primarily as functions of the type of die geometry. Experimental observations concerning the flow curves, the critical wall shear stress for the onset of the instabilities, the pressure and flow rate oscillations, and the effects of geometry and operating conditions are presented for linear low‐density polyethylenes. It is found that sharkskin and stick‐slip instabilities are present in the capillary and slit extrusion. However, annular extrusion stick‐slip and sharkskin are absent at high ratios of the inside‐to‐outside diameter of the annular die. This observation also explains the absence of these phenomena in other polymer processing operations such as film blowing. These phenomena are explained in terms of the surface‐to‐volume ratio of the extrudates, that is, if this ratio is high, sharkskin and stick‐slip are absent. POLYM. ENG. SCI., 2008. © 2007 Society of Plastics Engineers