Abstract
An analytical method is proposed for calculating the shaping parameters of thick sheet in the production of large-diameter pipe. This method is considered in several stages: formulation of a geometric model of the blank and the tool; numerical calculations; selection of the algorithm; and analysis of the results. Comparison of calculated and experimental shaping parameters for sheet used in the production of different types of large-diameter pipe reveals good agreement. The proposed method is recommended for calculating the shaping parameters in the production of large-diameter pipe and the setup so as to minimize the defects due to the geometry of the press.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
