Abstract
Manufacturing process through spray forming leads to give near-net-shape and fine grain microstructure. In this process Si particles, which are not distributed uniformly in conventional casting process, are distributed uniformly throughout the casting. In the present study disc shape spray form castings were made of Al-6.91Si and Al-10.1Si alloys, and then their shape, wear and mechanical properties were studied. The shape of the deposit was observed to be the most uniform at 30o inclination angle of the substrate. The hardness and tensile strength value of spray formed alloys shows the increment in the mechanical property in contrast to as cast alloys. The wearing properties of Al-10.1Si alloy were found to be better than that of the Al-6.91Si alloy.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
