Settling velocity and size distribution measurement of anaerobic granular sludge using microscopic image analysis

Abstract

Settling velocity and size distribution of anaerobic granular sludge samples were studied using microscopic image analysis and settling column experiments. Five granule samples were considered in this study. Three samples were collected at the Top, Middle and Bottom sections of a lab scale upflow anaerobic sludge bed reactor (UASB). Two other granule samples were obtained from industries. This paper aims to establish a method that uses microscopic image analysis and shape factor as a tool to determine the size distribution and settling velocity of anaerobic granules. Image analysis technique was used to calculate the shape factor and equivalent diameter of granules. The equivalent diameter was then used to calculate the theoretical settling velocities based on Allen's formula and estimate size distributions.The results showed that there was a good agreement between the theoretical and experimental mean settling velocity values. Both measured and calculated settling velocities increased with increasing Reynolds number (Re). However, the agreement between measured and calculated values was found to be weaker at higher Re values. Size distribution analyses of the granules have revealed that there was significant difference in the size distribution of granule samples collected at different heights of the lab scale reactor. Overall, granules from the bottom section of the reactor had larger diameter, settling velocity and shape factor than those at the middle and top section granules. Whereas granules collected from the top section exhibited the smallest granular diameter, settling velocity and shape factor.