Abstract
An experimental investigation was carried out to determine the setting time of cement based materials (cement paste, mortar, concrete, etc.). An original method based on measurements of both total lateral pressure and hydraulic pressure has been investigated. An original device has been engineered to measure the pressure kinetics. Just after mixing and filling of the device, a simultaneous drop and an equal value of the both hydraulic and total lateral pressures has been recorded. A definitive cessation of total lateral pressure and negative hydraulic pressures are then observed. The proposed setting time was defined as the elapsed time between the end of mixing and the time at which the hydraulic pressure becomes zero. In addition to the usual W / C parameter, the influence of the vibration and the height of the material tested on the pressure based method were studied. Comparing to other classical methods (Vicat, calorimetry, ultrasonic pulse-echo …), the presented device is efficient with major types of cement based materials (concrete, SCC …) and was able to give a simple and direct information about the mechanical state of the material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
