Sequential Smoothing Treatment of Glass Workpieces Cut by Abrasive Water Jet.

Abstract

A centrifugal disc and vibratory finishing machines were applied to improve the surface texture of soda-lime workpieces cut by an abrasive water jet. This innovative method was denoted as sequential smoothing treatment. An experimental study of the effect of the smoothing process conditions on the surface roughness, surface texture and micro roughness of the surface of glass workpieces was conducted. The analysis of the results obtained from experimental research made it possible to determine the optimum conditions for the smoothing process of glass workpieces after abrasive water jet cutting process. The proper selection of the finishing machine, machining media (abrasive chips) and compounds (liquids and powders) made it possible to reduce the surface roughness of areas located in the lower part of the cutting zone from Sa = 4.81 μm to Sa = 1.9 μm. The experimental results obtained confirmed the validity of using finishing machines to improve the surface quality of the soda-lime glass components. An important problem that requires further research is the increase in productivity and the reduction in machining time.