Abstract

In the present study, nano-sized TiO(2)/Al(2)O(3) modified polyvinylidene fluoride (PVDF) membranes (MM) were fabricated and then utilized for oil/water emulsion separation. The results showed that, compared with PVDF membrane (OM), the contact angle of MM decreased and hydrophilicity increased. The ultrafiltration (UF) of oil in water emulsions with transmembrane pressure (TMP) increasing results in a sharp fall in relative flux with time. The cake filtration models did not always predict the performance over the complete range of filtration times very well. In the initial 30 min, all the four cake models can simulate this UF process to a certain extent, and the suitability was: cake filtration > intermediate pore blocking > standard pore blocking > complete pore blocking models. However, they were no longer adapted well with UF time extent to 60 min, but only cake filtration (R(2) = 0.9535) maintained a high adaptability. Surface and cross-sectional morphology of the membrane was investigated by SEM to make an advanced certificate of this UF mechanism.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.