Separation of acid–water mixtures by pervaporation using nanoparticle filled mixed matrix copolymer membranes

Abstract

AbstractBACKGROUND: Low energy and less expensive membrane based separation of acetic acid‐water mixtures would be a better alternative to conventional separation processes. However, suitable acid resistant membranes are still lacking. Thus, the objective of the present study was to develop mixed matrix membrane (MMM) which would allow high flux and water selectivity over a wide range of feed concentrations of acid in water.RESULTS: Three MMMs, namely PANBA0.5, PANBA1.5 and PANBA3 were made by emulsion copolymerization of acrylonitrile (AN) and butyl acrylate (BA) with 5.5:1 comonomer ratio and in situ incorporation of 0.5, 1.5 and 3 wt%, sodium montmorilonite (Na‐MMT) nanofillers, respectively. For a feed concentration of 99.5 wt% of acid in water the membranes show good permeation flux (2.61, 3.19, 3.97 kg m−2 h−1 µm−1, for PANBA0.5, PANBA1.5 and PANBA3 membrane, respectively) and very high separation factors for water (1473, 1370, 1292 for PANBA0.5, PANBA1.5 and PANBA3 membrane, respectively) at 30 °C. Similarly for a dilute acid–water solution, i.e. for 71.6 wt% acid the membrane showed a very high thickness normalize flux (8.67, 9.44, 11.56 kg m−2 h−1 µm−1, for PANBA0.5, PANBA1.5 and PANBA3 membrane, respectively) and good water selectivity (101.7, 95.3, 79 for PANBA0.5, PANBA1.5 and PANBA3 membrane, respectively) at the same feed temperature. The permeation ratio, permeability, diffusion coefficient and activation energy for permeation of the membranes were also estimated.CONCLUSION: Unlike most of the reported membranes, the present MMMs allowed high flux and selectivity over a wide range of feed concentrations. These membranes may also be effective for separating other similar organic‐water mixtures. Copyright © 2012 Society of Chemical Industry