Abstract
As for the sensorless control of interior permanent magnet synchronous motor (IPMSM), conventional high frequency (HF) pulsating signal injection method is widely used, which uses band-pass filter (BPF) and low-pass-filter (LPF) based phase-locked-loop (PLL), however it may face the problems of poor stability and long convergence time. Therefore, an improved signal demodulation algorithm based on moving-average-filter (MAF)-PLL is proposed. MAF, which makes full use of the HF signal periodicity and half-wave symmetry, has higher bandwidth and better harmonics suppression ability than BPF or LPF. Furthermore, a proportional-integral (PI) regulator is used to gain the rotor speed and an integrator is applied to estimate rotor position. Compared with the conventional method, the proposed method gets rid of BPF and LPF, contributing to improving the stability and dynamic performance. Besides, undetermined parameters are reduced to one, i.e., window length of MAF, avoiding complex parameters design and selection. The proposed HF pulsating injection method has simpler signal demodulation process and is easy to implement. Finally, the experimental results have verified the feasibility and effectiveness of proposed method.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
