Abstract

Inland navigation networks are equipped with limnimeters to measure and record water level data for the control of water levels and the management of water resources. When faults occur on sensors, corrupted data can be considered as correct, leading to undesirable management actions. Therefore, it is necessary to detect and localize these faults. In this paper, the detection and localization of sensor faults is performed through the analysis of the parameters of a grey-box model, which are obtained from available real data. The parameters are determined with a sliding window, with the exception of the delays, which are considered known a priori. A fault is detected and then localized when there is a change in the value of the parameters. This approach is well suited for constant faults and particularly well adapted for intermittent faults. Data of an inland navigation reach located in the north of France are used to highlight the performance of the proposed approach.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.