Abstract

Abstract. Using a succession of 24 h Weather Research and Forecasting model (WRF) simulations, we investigate the sensitivity to initial soil moisture of a short-range high-temperature weather event that occurred in late July 2003 in East China. The initial soil moisture (SMOIS) in the Noah land surface scheme is adjusted (relative to the control run, CTL) for four groups of simulations: DRY25 (−25%), DRY50 (−50%), WET25 (+25%) and WET50 (+50%). Ten 24 h integrations are performed in each group. We focus on 2 m surface air temperature (SAT) greater than 35 °C (the threshold of "high-temperature" events in China) at 06:00 UTC (roughly 14:00 LT in the study domain) to analyse the occurrence of the high-temperature event. The 10-day mean results show that the 06:00 UTC SAT (SAT06) is sensitive to the SMOIS change; specifically, SAT06 exhibits an apparent increase with the SMOIS decrease (e.g. compared with CTL, DRY25 generally results in a 1 °C SAT06 increase over the land surface of East China), areas with 35 °C or higher SAT06 are the most affected, and the simulations are more sensitive to the SMOIS decrease than to the SMOIS increase, which suggests that hot weather can be amplified under low soil moisture conditions. Regarding the mechanism underlying the extremely high SAT06, sensible heat flux has been shown to directly heat the lower atmosphere, and latent heat flux has been found to be more sensitive to the SMOIS change, resulting in an overall increase in surface net radiation due to the increased greenhouse effect (e.g. with the SMOIS increase from DRY25 to CTL, the 10-day mean net radiation increases by 5 W m−2). Additionally, due to the unique and dynamic nature of the western Pacific subtropical high, negative feedback occurs between the regional atmospheric circulation and the air temperature in the lower atmosphere while positive feedback occurs in the mid-troposphere. Using a method based on an analogous temperature relationship, a detailed analysis of the physical processes shows that for the SAT change, the SMOIS change affects diabatic processes (e.g. surface fluxes) more strongly than the adiabatic process of subsidence in the western Pacific subtropical high in the five groups of simulations. Interestingly, although diabatic processes dominate subsidence during the daytime and night-time separately, they do not necessarily dominate during the 24 h periods (e.g. they are dominant in the WET and CTL simulations only). Further, as the SMOIS decreases, the SAT06 increases, which is largely due to the reduced cooling effect of the diabatic processes, rather than the warming effect of subsidence. Unlike previous studies on heatwave events at climate timescales, this paper presents the sensitivity of simulated short-term hot weather to initial soil moisture and emphasises the importance of appropriate soil moisture initialization when simulating hot weather.

Highlights

  • Under the background of global warming, heatwave events have occurred frequently worldwide, especially in the early 21st century

  • Unlike previous studies on heatwave events at climate timescales, this paper presents the sensitivity of simulated short-term hot weather to initial soil moisture and emphasises the importance of appropriate soil moisture initialization when simulating hot weather

  • We investigated the sensitivity of the temperature simulations to initial soil moisture using the Advanced Research Weather Research and Forecasting model (WRF) model (Version 3; Skamarock et al, 2008)

Read more

Summary

Introduction

Under the background of global warming, heatwave events have occurred frequently worldwide, especially in the early 21st century. In early July 2012, over half of America was hit by a persistent heatwave for approximately 1 week, and record-high temperatures were set in many places (Donat et al, 2013). These high-temperature and heatwave events directly threaten human health and safety and cause droughts and forest fires, which pose serious hazards to the entire ecological system and severely impact electrical power, transportation, and so forth (Tan et al, 2007; Zeng et al, 2011)

Objectives
Methods
Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.