Abstract

The accuracy in making Magnetic Sensitivity measurements of an integrated three-dimension Hall sensor can in general be very challenging. Sensitivity measurements are typically performed using an integrated coil system, which allows the generation of a low strength magnetic field. When the required field strength is greater than a few hundreds microTesla an external magnetic field source is needed. A new Test Hardware concept is presented to allow the calibration and test over temperature of a 3D hall integrated device. Calibration is performed by a direct measurement of the Sensitivity pre-trim of the three X, Y and Z sensors. The new test hardware gives the possibility to generate a stable and homogenous magnetic field and allows the test of the magnetic performances for any part in the production environment.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.