Abstract
The nanocomplex oxides of Sn-In and Sn-In-Ti were prepared by controlled co-precipitation method as sensing materials of semiconductor gas sensors for detection of CO, CH4 and NO2. Through manipulating the Sn/In cation ratio, metal salt total concentration, precipitation pH value and aging time, the nanocrystalline powders were successfully derived with chemical homogeneity and superior thermal stability, compared with the single component oxides. The particle size and morphology, surface area, and thermal and phase stabilities were characterized using TEM, TG-DTA, BET and XRD. The sensing tests showed that the Sn-In composites exhibit high sensitivity and selectivity for CO and NO2. The introduction of TiO2 enhanced CH4 sensitivity and selectivity, particularly, additives of Pd and Al2O3 as a dopant and surface modification greatly enhanced the sensing properties. The sensitivity depended on the composition of composites, calcination temperature and operating temperature. The optimal values were (25%In2O3-75%SnO2)-20%TiO2 for temary composite, 600 and 300°C, respectively. Temperature-programmed desorption (TPD) studies were employed to explain the gas adsorption behavior displayed by the surface of nanocomposites and X-ray photoelectron spectroscopic (XPS) analysis was used to confirm the electronic interactions existing between oxide components. The sensing mechanism of the nanocomposites was attributed to chemical and electronic synergistic effects.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
