Abstract
Thin plates (150 × 150 × 1.2mm) with embedded corrugation are fabricated using semisolid forming. The die cavity used in the forming is designed using fluid analysis. A semisolid slurry is prepared by a cooling with EMS and heating process. The slurry is then injected into a forging die attached to a 200 tonf hydraulic press. Subsequently, the slurry is compressed by a punch, flown into the die cavity, and then solidified. A356 (cast Al alloy) and AA6061, AA2024, and AA7075 (wrought Al alloys) are used.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
