Abstract

ObjectiveTo assess the feasibility and accuracy of a semi-autonomous two-stage dental robotic technique for zygomatic implants. MethodsTwenty-six zygomatic implants were designed and randomly divided into two groups using 10 three-dimensionally printed resin models with severe maxillary atrophy. In one group, the conventional drilling technique was used, in the other group, the drilling process for the alveolar ridge section (first stage) was completed, after which drilling for the zygoma section (second stage) was done. Based on preoperative planning combined with postoperative cone-beam computed tomography (CBCT), coronal, apical, depth, and angle deviations were measured. Zygomatic implant placement technique-related deviations (sinus slot, intrasinus, and extrasinus) were also recorded and analyzed. ResultsThe two-stage technical group's coronal, apical, depth, and angle deviations were 0.57 ± 0.19 mm, 1.07 ± 0.48 mm, 0.30 ± 0.38 mm, and 0.91 ± 0.51°, respectively. The accuracy of the two-stage technique was significantly higher than that of the conventional one-stage technique (p < 0.05). The apical deviation in the intrasinus group was 1.12 ± 0.56 mm, which was significantly better than that in the other two groups (p < 0.05). The angle deviation in the sinus slot group was 1.96 ± 0.83°, which was significantly worse than that in the other two groups (p < 0.05). ConclusionUsing the semi-autonomous two-stage dental robotic technique for zygomatic implants is feasible and is more accurate than using the conventional one-stage technique. Clinical significanceThe two-stage technique enabled the semi-autonomous robot to overcome the mouth-opening restriction for zygomatic implants and improved accuracy.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call