Abstract
Miniature-testing is essential to characterize the plastic response of materials for which the extraction of conventional full-size specimens is impossible. Examples are weld regions with high property gradients or electronic circuit components. Here, we present the design of a novel testing system for miniature specimens. After inserting the specimens with wedge-shaped shoulders, the system carries out the clamping, initial geometry scanning, and mechanical testing with digital image correlation in an automated manner. The automation prevents the accidental damaging of the miniature specimens during manual handling and adds to the robustness of the overall procedure. It is shown that the experiments with miniature specimens extracted from DP600 steel and aluminum 7075-T6 are highly reproduceable. More importantly, they lead to the same plasticity and fracture properties as experiments on conventional ten-times larger full-size specimens. A correction procedure accounting for the surface roughness, white layer and heat affect zone induced through wire EDM is provided. In addition to developing and validating the new experimental technique, it is applied to characterize a 22MnB4 rod material and stainless steel 316 L foil.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
