Self-contained calibration samples and measurements of the thermoelectric figure of merit: A method to improve accuracy

Abstract

Despite more than seven decades of active research and development in thermoelectricity, the accurate measurement of the thermoelectric (TE) properties of bulk materials has remained a challenge, mainly because of the strong interrelation between thermal and electrical phenomena. This work highlights practical advancements in methods and instrumentation dedicated to the simultaneous measurements of TE properties such as the Seebeck coefficient (S), the thermal (κ), and electrical (σ) conductivities and the dimensionless TE figure of merit ZT = S2σT/κ. The accuracy of a Harman based approach, as implemented by the ZT-Scanner (TEMTE Inc.), applicable to the simultaneous measurement of the above TE properties, has been made possible by a self-contained calibration procedure, which is based on the availability of two samples of the same homogeneous material having different shape factors. It is of practical importance that this approach provides a simple procedure to obtain the calibration for the figure of merit ZT and the thermal conductivity in the temperature interval from 300 to 720 K. In addition, we show that a simplified Harman setup with no thermocouples attached to the sample can also be used for self-contained calibrated ZT measurements. It is concluded that the implemented steady-state approach decreases the relative error down to 1%–2% for ZT measurements and can be recommended for most applications not involving dynamical behavior. In particular, it is proposed that self-generated calibration samples can critically increase the quality and ease of comparison of TE measurements if they are adopted by the TE community.