Abstract
Carbon-encapsulated SnO2 hollow spheres were fabricated by a self-templating method from Sn spheres for lithium-ion batteries (LIBs). High-temperature annealing (e.g., 700 °C) inevitably led to the formation of Sn on the exterior surface, which was disadvantageous for long-term cycling. In contrast, the preparation at an optimal annealing temperature of 600 °C coupled with subsequent acid etching completely encapsulated the SnO2 within a carbon shell while maintaining a stable hollow structure. The as-prepared carbon-encapsulated SnO2 hollow spheres after acid etching (SnO2@C–6H) exhibited enhanced electrochemical performance for LIBs characterized by high cycling stability and rate capacity. Specifically, SnO2@C–6H displayed a reversible capacity of 897.9 mA h g−1 at 200 mA g−1 after 120 cycles and a promising rate capacity of 549.8 mA h g−1 at a high current density of up to 2000 mA g−1. The obtained high-performance could be attributed to the formation of a unique hollow structure with an enlarged specific surface area of 215.18 m2 g−1 and a relatively high degree of graphitization (i.e., ID/IG = 0.84) of the carbon shell. A plausible cause for this performance was that the acquired hollow spheres not only provide a barrier effect for volume expansion and the aggregation of SnO2, but also promote lithium storage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.