Selective Wet Etching of Silicon Germanium in Composite Vertical Nanowires.

Abstract

Silicon germanium (SixGe1-x or SiGe) is an important semiconductor material for the fabrication of nanowire-based gate-all-around transistors in the next-generation logic and memory devices. During the fabrication process, SiGe can be used either as a sacrificial layer to form suspended horizontal Si nanowires or, because of its higher carrier mobility, as a possible channel material that replaces Si in both horizontal and vertical nanowires. In both cases, there is a pressing need to understand and develop nanoscale etching processes that enable controlled and selective removal of SiGe with respect to Si. Here, we developed and tested solution-based selective etching processes for SiGe in composite (SiNx/Si0.75Ge0.25/Si) vertical nanowires. The etching solutions were formed by mixing acetic acid (CH3COOH), hydrogen peroxide (H2O2), and hydrofluoric acid (HF). Here, CH3COOH and H2O2react to form highly oxidizing peracetic acid (PAA orCH3 CO3H). The hydrofluoric acid serves both as a catalyst for PAA formation and as an etchant for oxidized SiGe. Our study shows that an increase in anyofthe two oxidizer(H2O2 and PAA)concentrations increases the etch rate, and the fastest etch rate of SiGe is associated with the highest PAA concentration. Moreover, using in situ liquid-phase TEM imaging, we tested the stability of nanowires during wet etching and identified the SiGe/Si interfaceto be the weakest plane; we found that once the diameter of the 160-nm-tall Si0.75Ge0.25 nanowire reaches ∼15 nm during the etching, the nanowire breaks at or very close to this interface. Our study provides important insight into the details of the nanoscale wet etching of SiGe and some of the associated failure modes that are becoming extremely relevant for the fabrication processes as the size of the transistors shrink with every new device generation.