Abstract
The quest for a circular economy has directed attention towards processing of end-of-life products and industrial streams to recover the valuable fractions these contain. Fluorescent lamp waste is acknowledged to be an important source of yttrium and europium, two of the rare earth elements presently regarded as having critical supply risk. In this study, a commercial extractant for solvent extraction separations of REEs, Cyanex 572, was successfully applied to separate yttrium and europium from solutions obtained during processing of fluorescent lamp waste streams. Yttrium was selectively separated from europium at pHeq=0, followed by further recovery of europium at pHeq=1. Better extraction efficiencies of REEs were achieved using aliphatic diluents e.g. kerosene in comparison to aromatic diluents or long chain alcohols. Increases in temperature in the range 25–65°C led to decreases in the separation factors between yttrium and europium. Stripping with hydrochloric acid solutions at concentrations higher than 3M led to complete recovery of extracted yttrium and europium. Precipitation of these elements from their respective stripping products with oxalic acid, followed by calcination of the precipitate, led to yttrium and europium oxides of 99.82% and 91.60% purity, respectively. A flowsheet that encompass the main steps for fluorescent lamp waste processing is also presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.