Abstract
Introduction/Objective. The objective of this paper is to describe the microstructure and mechanical properties of sintered Co-Cr alloy and to emphasize its advantages and disadvantages with respect to the microstructure and mechanical properties of cast Co-Cr alloy. Methods. Base Co-Cr alloy, EOSint M EOS Co-Cr SP2 (EOS GmbH, Munch, Germany), was used for the purpose of this research as the base material for sintering metal structures of metal-ceramic restorations. Metal sintering was conducted by using EOSint M 280 device of German origin in a stream of neutral gas ? argon. After that, the alloy was heated over a period of 20 minutes at the temperature of 800?C. The chemical composition of the alloy was determined by energy dispersive spectroscopy. Microstructure of the tested alloy samples was examined under an optical metallographic and scanning electron microscope. Physical and mechanical properties were measured in a universal testing machine. The samples were prepared according to the standard ISO 527-1:1993. Results. Chemical composition of the sintered Co-Cr alloy, determined by applying energy dispersive spectroscopy, indicated the same qualitative but different quantitative composition compared to cast Co-Cr alloys. The microstructure of the sintered Co-Cr alloy is lamellar in nature, with two dominant phases: ?-Co and/or ?-Cr (fcc ? face-centered cubic) and ?-Co (hcp ? hexagonal close-packed). Mechanical properties of the Co-Cr alloy obtained by applying selective laser melting technology compared to the cast Co-Cr alloy are superior or approximately the same. Conclusion. Selective laser melting of the Co-Cr alloy is a good example of new technologies based on digitization. Together with other digitized procedures, this technology is an introduction to a new era in dentistry popularly called Dentistry 4.0. The advantages of the selective laser melting technology with respect to the conventional technology of casting Co-Cr alloy metal structures are precise metal structure fitting and eco-friendly technology.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.