Selective Isotropic Dry Etching of SiO2 Using F/H-Based Pulsed Remote Plasma and a Vapor Phase Solvent

Abstract

Isotropic etching generally employs liquid-based wet etching techniques. However, due to the high integration of devices, conformal etching is challenging in patterns with a high aspect ratio because liquid chemicals struggle to penetrate inside the pattern. Additionally, during the drying process after chemical treatment, pattern collapse is observed due to surface tension. Therefore, there is a need for dry isotropic etching techniques to replace wet etching techniques in next-generation device manufacturing processes.Typically, when high selectivity SiO2 isotropic dry etching is required, F-base/H-based gas mixtures are utilized to form HF, which serves as an etchant for SiO2. SiO2 can be dry etched through two different mechanisms. First, HF reacts directly with H2O or alcohol, etching SiO2. The other way is to produce (NH4)2SiF6 salt from the reaction of NH3, which can be formed in a plasma containing NH3 and NF3. This (NH4)2SiF6 salt is sublimated and removed by a following heating process at a temperature over 100ºC.The process above has some disadvantages, such as lowering the etch selectivity of SiO2 over Si and Si3N4 because Si and Si3N4 can be etched by F radicals remaining in the plasma. This study aimed to overcome these disadvantages by controlling the F radical through pulsing the remote plasma during the discharging of F-based/H-based gas mixtures for the formation of HF. By pulsing the remote plasma, SiO2 could be selectively etched at a higher etch rate relative to those of Si and Si3N4. Additionally, various types of H/F-based gas mixtures that do not contain nitrogen while producing HF were investigated to prevent the formation of ammonium powders, which can be a source of contamination in the chamber. Futhermore, the etching mechanisms were identified through gas phase anlysis and surface analysis. Also, any possible surface damage during the etching process was investigated.