Selective iron removal from spent passivation baths by ion exchange

Abstract

AbstractBACKGROUND: Post‐treatment of zinc plated surfaces is required to provide corrosion protection; for this purpose chromium passivation is usually used. In the EU, the older hexavalent chromium passivation baths have been replaced by trivalent chromium conversion coatings. However, the life of Cr(III) passivation baths is reduced due to iron and zinc impurities generated in the process. Thus, the objective of this work was to investigate the regeneration of spent passivation baths from the plating industry by ion exchange using a new chelating resin (Purolite S‐957).RESULTS: Three genuine passivation baths with different iron and zinc concentrations were investigated; the effect of loading flow rate, temperature and resin regeneration conditions on the uptake of iron ions was also studied. The removal performance of iron was increased at higher temperature (55 °C) and lower flow rates. The best regeneration conditions were found to be 6 bed volumes (BV) of 30 wt% HCl.CONCLUSION: This work has shown that iron can be selectively removed from trivalent chromium passivation baths using a new chelating resin (Purolite S‐957) and no addition of chromium (III) is required. Low feed flow rate and high bath temperature (up to 55 °C) are recommended for high iron uptake. Copyright © 2008 Society of Chemical Industry