Abstract
There have been diverse fatigue models and approaches to properly estimate solder joint reliability. However, it is one of the most difficult problems to determine which solder constitutive models and fatigue models can be applied best. In this paper, both viscoplastic and elastic-plastic-creep solder constitutive models could be utilized to calculate accumulated inelastic response under 208 K to 423 K(-65 °C to 150 °C) thermal cycling condition. And two different fatigue models, Darveaux and creep-fatigue model were applied to find solder joints fatigue life for flip chip assembly. Moreover, each fatigue life was compared to experimental result for the validation of finite element analysis. The actual number of cycles to failure was obtained from cross sectional view of the package with SEM.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
