Selection of EU-DEMO divertor operating conditions: water cooling thermal-hydraulic parameters and power exhaust capabilities

Abstract

In the context of EUROfusion activities for the development of the DEMO reactor project, the divertor design is a major challenge. It must sustain very high heat, ion particle and neutron fluxes allowing, at the same time, the shielding of the vacuum vessel and the vacuum pumping for reducing the plasma pollution. The conceptual divertor design is based on the use of EUROFER97 for the divertor cassette body, while tungsten monoblocks bonded to CuCrZr pipes are used for plasma-facing targets. EUROFER97 was selected considering its reduced long-term activation and superior creep and swelling resistance under neutron irradiation. However, depending on the operating temperature under neutron irradiation, a pronounced shift of the Ductile to Brittle Transition Temperature (DBTT) is expected. At the same time, for the plasma-facing targets, the coolant temperature has to be identified such to allow sufficient heat removal capacity at the strike point. This study explores alternative cooling conditions for the divertor system that are able to ensure the fulfillment of functional and system requirements and to allow for divertor cassette body re-use during plant lifetime. The main aim is to identify the best water cooling thermal-hydraulic conditions avoiding material embrittlement (for EUROFER 97) and softening/hardening (for copper alloy pipes). At the same time, the goal is to reduce the inventories (enthalpy of the cooling circuit) and the radwaste at the end of divertor lifetime.