Seismoelectric wave conversions in porous media: Field measurements and transfer function analysis

Abstract

We present a series of field experiments showing the transient electric fields generated by a seismic excitation of the subsurface. After removing the powerline noise by adaptive filtering, the most prominent feature of the seismoelectric recordings is the presence of electric signals very similar to conventional seismic recordings. In one instance, we identified small‐amplitude precursory electromagnetic disturbances showing a polarity reversal on either side of the shotpoint. Concentrating on the dominant seismoelectric effect, we theoretically show that the electric field accompanying the compressional waves is approximately proportional to the grain acceleration. We also demonstrate that the magnetic field moving along with shear waves is roughly proportional to the grain velocity. These relationships hold true as long as the displacement currents are much smaller than the conduction currents (diffusive regime), which is normally the case in the low‐frequency range used in seismic prospecting. Furthermore, the analytical transfer functions thus obtained indicate that the electric field is mainly sensitive to the salt concentration and dielectric constant of the fluid, whereas the magnetic field principally depends on the shear modulus of the framework of grains and on the fluid’s viscosity and dielectric constant. Both transfer functions are essentially independent of the permeability. Our results suggest that the simultaneous recording of seismic, electric, and magnetic wavefields can be useful for characterizing porous layers at two different levels of investigation: near the receivers and at greater depth.