Seismic performance analysis and control method of composite coupled shear wall with steel plate-fiber reinforced concrete coupling beams

Abstract

This paper based on the study of steel plate-fiber reinforced concrete coupling beam components, designs a basic model of composite coupled shear walls with steel plate-fiber reinforced concrete coupling beams. The seismic performance of this model was numerically simulated using the ABAQUS finite element software, analyzing the stress distribution of various parts and the development pattern of plastic hinges in the structure. It also examines how factors such as axial compression ratio, coupling beam cross-sectional dimensions, single-sided wall limb aspect ratio, and total floor height affect the seismic performance of this type of coupled shear wall, providing a reasonable range for axial compression ratios and coupling ratios for composite coupled shear walls with steel plate-fiber reinforced concrete coupling beams. Based on the obtained reasonable axial compression ratio and coupling ratio, and using the analytical solution of the continuum method, a method for controlling the seismic performance of coupled shear wall structures was proposed. Results show that the composite coupled shear walls with steel plate-fiber reinforced concrete coupling beams exhibit high load-bearing capacity and lateral stiffness under inverted triangular horizontal loads, with good displacement ductility and strong energy dissipation capability, making it an excellent seismic performance coupled shear wall system. As the axial compression ratio increases, the displacement corresponding to the yield point and peak point of the structure gradually decreases, and the displacement ductility coefficient shows a trend of first increasing and then decreasing; it is recommended that when designing steel plate-fiber reinforced concrete coupling beam-coupled shear walls, the axial compression ratio should not exceed 0.3. Numerical analysis of coupling ratio-related parameters indicates that in high-intensity seismic design areas, the range of coupling ratios should be between 45% and 60%.