Abstract

Abstract. Crustal faults located close to cities may induce catastrophic damages. When recurrence times are in the range of 1000–10 000 or higher, actions to mitigate the effects of the associated earthquake are hampered by the lack of a full seismic record, and in many cases, also of geological evidences. In order to characterize the fault behavior and its effects, we propose three different already-developed time-integration methodologies to define the most likely scenarios of rupture, and then to quantify the hazard with an empirical equation of peak ground acceleration (PGA). We consider the following methodologies: (1) stream gradient and (2) sinuosity indexes to estimate fault-related topographic effects, and (3) gravity profiles across the fault to identify the fault scarp in the basement. We chose the San Ramón Fault on which to apply these methodologies. It is a ∼ 30 km N–S trending fault with a low slip rate (0.1–0.5 mm yr−1) and an approximated recurrence of 9000 years. It is located in the foothills of the Andes near the large city of Santiago, the capital of Chile (> 6 000 000 inhabitants). Along the fault trace we define four segments, with a mean length of ∼ 10 km, which probably become active independently. We tested the present-day seismic activity by deploying a local seismological network for 1 year, finding five events that are spatially related to the fault. In addition, fault geometry along the most evident scarp was imaged in terms of its electrical resistivity response by a high resolution TEM (transient electromagnetic) profile. Seismic event distribution and TEM imaging allowed the constraint of the fault dip angle (∼ 65°) and its capacity to break into the surface. Using the empirical equation of Chiou and Youngs (2014) for crustal faults and considering the characteristic seismic event (thrust high-angle fault, ∼ 10 km, Mw = 6.2–6.7), we estimate the acceleration distribution in Santiago and the hazardous zones. City domains that are under high risk include the hanging wall zone covered by sediments and narrow zones where the fault could break the surface. Over these domains horizontal PGA can be greater than 0.5 g and eventually produce building collapse.

Highlights

  • In active margins, sustainable balance between city development and geological environment requires understanding seismic hazard to reduce the associated risks

  • Some seismic events are associated with a hypothetical high angle fault (60–65◦ dip, five events), whereas the low angle fault scenario (30◦ dip) does not fit with the observed seismicity depth distribution

  • Natural seismicity registered in a 1-year local network is compatible with San Ramón Fault (SRF) activity

Read more

Summary

Introduction

Sustainable balance between city development and geological environment requires understanding seismic hazard to reduce the associated risks. Assessment is more difficult when none of these conditions are met An example of this case is the San Ramón Fault (SRF) in the southern Andes (Fig. 1), located in the foot hills of Santiago, the highly populated capital of Chile (> 6 000 000 inhabitants) (Armijo et al, 2010; Farías et al, 2008; Rauld et al, 2006; Vargas et al, 2014). We chose this case for the high potential risk associated with it and for the chance to propose and test an integrated methodology to estimate seismic hazard

Objectives
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call