Abstract
Two different reactive concentrated magnesium hydroxide (HM) pulps, produced in a lab reactor mill, and a synthetic and non-reactive HM-pulp, for comparative analyses, have been prepared and studied. Sodium polyacrylate was selected as a dispersant for improving the HM pulp fluidity, with concentrations varying from 0.42% to 2.0% on a dry basis. The two reactive pulps differed from each other mainly by the impurity level and for both, a residual MgO amount was detected, implying that the hydration reaction could proceed. Results (with and without dispersant) confirmed the formation of particle clusters as HM concentration rose until a critical value, above which the pulp behaved as a solid. Reactive HM-pulps with high impurities may represent a limiting factor in the drying operation. Among all HM-pulps studied, the purest reactive pulp with 1% dispersant presented the best flow behavior making this reactive pulp the most suitable to be tested in a pilot spray dryer.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
