Second generation bioethanol from Eucalyptus globulus Labill and Nothofagus pumilio: Ionic liquid pretreatment boosts the yields

Abstract

The depletion of petroleum reserves and the high level of pollution caused by fossil fuels have led to enhancing renewable energy and fuel production from biomass. Eucalyptus globulus and Nothofagus pumilio residues could constitute an interesting source of biomass for second generation biofuel production. Lenga residues were pretreated with the ionic liquid (IL) 1-N-ethyl-3-methylimidazolium chloride (C2mimCl), followed by subsequent fermentation using both the strategy of Simultaneous Saccharification and Fermentation (SSF) as well as Separate Hydrolysis and Fermentation (SHF). The SHF process yielded 0.134g ethanol/g glucose (26.3wt-% of the theoretical yield) compared to the SSF process which yielded 0.173g ethanol/g glucose (33.9wt-% of the theoretical yield) within the first 24h of fermentation. In case of Eucalyptus residues, another IL, 1-N-ethyl-3-methylimidazolium acetate (C2minOAc) was applied. The SSF process was applied for a period of three days. As a result, 3.7g ethanol/L (corresponding to a yield of 0.19g of ethanol/g of glucose or 38.0wt-% of the theoretical maximum) was obtained at 72h. When fresh Lenga and Eucalyptus residues were fermented without any pretreatment, the SSF process yielded 0.017 and 0.002g of ethanol/g of glucose, respectively (3.33wt-% and 0.48wt-% of the theoretical maximum, respectively). Thus, the pretreatment procedures resulted in a significant increase in ethanol production, therefore justifying the need of pretreatment prior to the co-enzyme hydrolysis and fermentation for this type of biomass. Further, the combination of IL pretreatment and use of SSF process demonstrated the high potential for bioethanol production from Lenga and Eucalyptus residues. Nevertheless, further improvement by optimization of operational conditions is required to maximize the ethanol yield.