Abstract

Aerosol particles are important due to their direct and indirect impacts on climate. Within the planetary boundary layer (BL), these particles have a relatively short lifetime due to their frequent removal process by wet deposition. When aerosols are transported into the free troposphere (FT), their atmospheric lifetime increases significantly, making them representative of large spatial areas. In this work, we use a combination of in situ measurements performed at the high altitude PUY (Puy de Dôme, 45°46′ N, 2°57′ E, 1465 m a.s.l) station, together with LIDAR profiles at Clermont-Ferrand for characterizing FT conditions, and further characterize the physical properties of aerosol in this poorly documented area of the atmosphere. First, a combination of four criteria was used to identify whether the PUY station lies within the FT or within the BL. Results show that the PUY station is located in BL with frequencies ranging from 50% during the winter, up to 97% during the summer. Then, the classification is applied to a year-long dataset (2015) of particle size distribution data to study the differences in particle physical characteristics (size distribution) and black carbon (BC) concentrations between the FT and the BL. Although BC, Aitken, and the accumulation mode particles concentrations were higher in the BL than in the FT in winter and autumn, they were measured to be higher in the FT compared to BL in spring. No significant difference between the BL and the FT concentrations was observed for the nucleation mode particles for all seasons, suggesting a continuous additional source of nucleation mode particles in the FT during winter and autumn. Coarse mode particle concentrations were found higher in the FT than in the BL for all seasons and especially during summer. This indicates an efficient long-range transport of large particles in the FT from distant sources (marine and desert) due to higher wind speeds in the FT compared to BL. For FT air masses, we used 204-h air mass back-trajectories combined with boundary layer height estimations from ECMWF ERA-Interim to assess the time they spent in the FT since their last contact with the BL and to evaluate the impact of this parameter on the aerosol properties. We observed that even after 75 h without any contact with the BL, FT aerosols preserve specific properties of their air mass type.

Highlights

  • Aerosol particles affect climate through both direct and indirect effects, as well as being an important factor in public health [1]

  • We focus on the physical characteristics of aerosol particles measured at the Puy de Dôme station (PUY) station using a Scanning Mobility Particle Sizer (SMPS) and a GRIMM optical particle counter (OPC) [33] for particle size distribution measurements and a Multi-Angle Absorption Photometer (MAAP) for absorption properties and aerosol black carbon (BC) content

  • Four different criteria were investigated in the present work to determine when the PUY station is sampling in the boundary layer (BL)/AL or in the free troposphere (FT), including the analysis of LIDAR profiles, radon concentration, the ratio of concentrations and European Center for Medium-Range Weather Forecasts (ECMWF) outputs

Read more

Summary

Introduction

Aerosol particles affect climate through both direct and indirect effects, as well as being an important factor in public health [1]. In addition to pioneer methods based on vertical temperature profiles [5,6], several techniques have been developed to determine the BLH Those include radio sounding system [7], active remote sensing such as ceilometer, SODAR and LIDAR [8,9], in situ measurements of trace gases, aerosol particles concentrations, and wind direction from high altitude sites [3,10,11,12] as well as atmospheric models [13,14]. Aerosol particles transported into the FT or formed in the FT can be re-injected again into BL, affecting the air quality far from the source region [20,21] For these reasons, it is important to characterize the properties of FT aerosols. The segregation between BL and FT air masses is used to investigate the differences in aerosol properties belonging to each of these atmospheric layers over the 12-month period

Site and Instrumentations
Particle Number Size Distribution
Gas-Phase Measurements
ECMWF-ERA-Interim and LACYTRAJ
Results and Discussion
January
(Figures
The from versusLIDAR
Comparison of the Four Criteria
Classification of Air Masses by Combining Four Criteria
The combined classification
UTCa for summerat and to masses reach aare minimum at at
Comparisons of the Free Troposphere and Boundary Layer Aerosol Properties
11. The air masses in the FT of fornucleation winter andmode autumn seasons
Another
Conclusions
Introduction to Boundary
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.