Abstract
Studies for corrugated metal gaskets are still ongoing to improve its performance. This is considered to be a single gasket with SUS304 material when contact with flanges that have greater surface roughness, reduced contact width and plastic deformed contact surfaces are incomplete and cannot fill the surface roughness of flanged flanges. The use of softer material than the base material as a surface covering material is used to improve the performance of the gasket. In this study, therefore the effect of modulus of elasticity ratio and thickness ratio on contact width and contact stress, 25A three-layer metal gasket was investigated using Finite Element Analysis. The results showed that the material with tangent modulus, Ehal = Eal / 150 had the highest slope for contact width. While the contact width of the plastic mode gasket is higher than the elastic mode gasket.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
