Abstract

Robotic assembly is difficult as there always exist position errors between two mating parts. Compliance is added in a selective compliant assembly robot arm (SCARA) in the form of a two ionic polymer metal composite (IPMC) fingers based micro gripper. This micro gripper is integrated at the end effector position of a SCARA robot. Peg-hole interaction is analytically modeled and based on it the force required to correct the lateral and angular errors by IPMC is calculated. A proportional-derivative (PD) controller is designed to actuate the IPMC to get the desired force for correcting the peg position before assembly. Simulations and experiments were carried out by developing an IPMC micro gripper and using it to analyze various cases of peg in hole assembly. The experimental results prove that adding compliance through IPMC helps in peg-in-hole assembly.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.