SCALE-UP OF CONTACT DRYERS

Abstract

ABSTRACT The scale-up of contact dryers is still based on experimental drying curves. In order to keep the effort to a minimum the drying curve is determined using a small laboratory or pilot dryer of similar geometry to the production dryer. This paper introduces a new scale -up method for contact dryers. The new scale-up method is based on the assumption that heat transfer is the controlling mechanism. The scale-up method is derived from the material balance, the energy balance, the kinetic equation of heat transfer and thermodynamic equilibrium. The scale up method can be used to convert the drying time required to achieve a certain residual moisture content from the laboratory or pilot dryer to the production dryer and/or different drying conditions. The scale-up method was verified by drying test with four different products in conical mixer dryers of 1, 60, 250, 1000 I volume. Two products were free flowing and two products were non free flowing in the wet state. The products can be considered non-h...