Abstract
AbstractHydraulic models differing from prototype scale are affected by model effects. Despite these effects, which are often negligible, they may become important in very small scales involving, for instance, small water depths. A scale family is a convenient method to detect these effects in a new test setup to demonstrate the equipment applicability. The scale family investigated here involves a previously installed test setup concerning the impulse wave run-up and overland flow. Solitary waves as a typical wave type of slide-generated impulse waves were analyzed using a pneumatic piston-type wave generator. Free surface profiles were measured to investigate the maximum flow depths and the flow front velocities. The observed scale effects led to the definition of the minimum Reynolds and Weber numbers for the considered test setup, above which scale effects can be neglected.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Waterway, Port, Coastal, and Ocean Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.