Abstract
Since the first report in 2009 with a power conversion efficiency (PCE) of 3.8%, perovskite solar cells (PSCs) have become the hot research topic in the field of photovoltaics and rapidly achieved a certified PCE of 25.5% within just a decade. Compared to its counterparts such as single‐crystalline silicon solar cells or CIGS, PSCs present the obvious advantages of low cost and solution processability. However, the most efficient PSCs are mainly based on devices with an active area of less than 0.1 cm2 by a conventional spin‐coating method in the lab. To put forward the commercialization of PSCs, it is mandatorily required to manufacture a large‐scale PSC module with practical and scalable fabrication techniques. As one of the most viable and promising scalable techniques, the blade coating process with various types available (including doctor‐blade coating, slot‐die coating, roller coating) has been widely investigated due to many attractive merits of high PCE, easy operation, low cost with cheap facilities, and high materials utilization ratio. Herein, the challenges of fabricating large‐area PSCs and manipulation of film quality for highly efficient PSCs fabricated with blade coating are introduced and discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
