Abstract
Thermoset co-injection moulding is a novel technology that might be an alternative for thermoset recycling. This paper describes some experiments on the sandwich moulding of two polyesters, a powder coating and a BMC using a new special design thermoset co-injection machine and manifold system. The first thermoset sandwich moulding has been made and a number of initial moulding problems are presented and discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Progress in Rubber, Plastics and Recycling Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
