Abstract
ABSTRACT Contact electrification is a direct triboelectrification method for producing current through charge transfer when two different differentiated materials have brought into contact. For the first time, we developed a simple triboelectric nanogenerator (TENG) where the electronic charges were realized through contact separation mode between sand-polished Kapton (SPK) and Al surface. Here, we demonstrated the energetic interfacial contact between these surfaces and observed satisfactory output performance. The novel SPK-TENG produced 40 V and 2.8 µA, of open-circuit voltages (V oc) and short-circuit currents (I sc) at 4 Hz, respectively. Mainly, the SPK-TENG was dramatically increased up the performance of TENG, up to 40% of V oc and 42% of I sc, with respect to the Kapton film because the mobility of electrons is very high on the device surface compared to the other pristine Kapton film. The fabricated SPK-TENGs were good candidates for satisfying the need for alternative contact separation mode TENGs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.