Sampling sufficiency for determining hydraulic habitat diversity

Abstract

The geometry and hydrodynamics of river reaches are key ecohydraulic descriptors. Statistics of water depth and velocity measurements are usually taken as proxies for habitat suitability in rivers. However, little is known about the sufficiency of data to produce effective and representative results. In this research, 19 reaches with differences in terms of discharge, river width, substrate, reach length, cross-section spacing and geomorphology are investigated. Measurements of flow depth and velocity were taken at multiple, equally spaced cross-sections along each reach. Data were sub-sampled using different methodologies and analysed each time. The sets of sub-sampled data were then compared with those calculated with the full data set from a reach. The focus was put towards the hydro-morphological index of diversity (HMID), a combination of the classical ecohydraulic variables flow depth and velocity. It represents the spatial variability of hydraulic habitats in a reach. The results point out that, with a well-defined sampling strategy, 100 measurement points lead to a good estimation of the HMID value in a reach, if more than eight measurement points are taken per cross-section. For geomorphologies with small complexity or when the analysis only includes the estimation of mean flow depth or mean flow velocity, this number can be decreased according to the results presented here. These findings help both, aquatic ecologists and engineers to estimate their data reliability for hydraulic field measurements in a river reach and are herein discussed taking into account the different studied morphologies.