Abstract
The contact mode high-speed atomic force microscope (AFM) operates orders of magnitude faster than conventional AFMs. It is capable of capturing multiple frames per second with nanometre-scale lateral resolution and subatomic height resolution. This advancement in imaging rate allows for microscale analysis across macroscale surfaces, making it suitable for applications across materials science. However, the quality of the surface analysis obtained by high-speed AFM is highly dependent upon the standard of sample preparation and the resultant final surface finish. In this study, different surface preparation techniques that are commonly implemented within metallurgical studies are compared for samples of SAF 2205 duplex stainless steel. It was found that, while acid etching and electrolytic etching were optimal for the low resolution of optical microscopy, these methods were less suited for analysis by high resolution high-speed AFM. Mechanical and colloidal silica polishing was found to be the optimal method explored, as it provided a gentle etch of the surface allowing for high quality topographic maps of the sample surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.