Safety assessment of the process “Coveris”, based on Starlinger Decon technology, used to recycle post‐consumer PET into food contact materials

Abstract

This scientific opinion of the EFSA Panel on Food Contact Materials, Enzymes, Flavourings and Processing Aids deals with the safety evaluation of the recycling process Coveris (EU register No RECYC0126), which is based on the same Starlinger Decon technology. The decontamination efficiency of the process was demonstrated using the same challenge test. The input of this process is washed and dried poly(ethylene terephthalate) (PET) flakes originating from collected post-consumer PET containers, mainly bottles, containing no more than 5 % of PET from non-food consumer applications. In this technology washed and dried PET flakes are pre-heated before being Solid State Polycondensed in a continuous reactor (SSP) at high temperature under vacuum and gas flow. Having examined the challenge test provided, the Panel concluded that the pre-heating (step 2) and the decontamination in the continuous SSP reactor (step 3) are the critical steps that determine the decontamination efficiency of the process. The operating parameters that control their performance are well defined and are temperature, pressure, residence time and gas flow for step 2 and 3. Under these conditions it was demonstrated that the recycling process under evaluation, using a Starlinger Decon technology, is able to ensure that the level of migration of potential unknown contaminants into food is below a conservatively modelled migration of 0.1 µg /kg food. Therefore, the Panel concluded that the recycled PET obtained from this process intended to be used up to 100 % for the manufacture of materials and articles for contact with all types of foodstuffs for long term storage at room temperature, with or without hotfill is not considered of safety concern. Trays made of this PET are not intended to be used, and should not to be used in microwave and conventional ovens.